I saw a post on Craftster where she used and old plastic hanger to make a Chip Clip. I can't resist a goo recycle project, but... I did add one thing to mine so I thought I would share.
I followed her tutorial pretty much the same. Above is just a disposable plastic pants hanger.
I started using the knife to saw it, but found it actually went faster when I simple pushed hard. I did this on both sides and and then snapped the clips off the rest of the way. Problem with this for me was that it left a jagged edge. Not something particularly sharp, but still... if BUGGED ME! Call me crazy.
I a did was use a lighter to melt the edges. I didn't do this one the counter like in the picture, but... I couldn't hold the clip, the lighter and my camera!
See! All done. Thank you Craftster!